With many years of use, water heaters tend to show signs of wear and tear and need to be fixed. Before you call professional water tank experts for water heater repair services, here are a few things you can do yourself as quick fixes for your water heater.
Your water heater operates on electricity, and water and electricity are a fatal combination. To avoid risking an electrocution, turn off the electrical supply to your water heater before you start to work on your water heater repair.
You must also turn off the water supply to your water heater to avoid a major flood in your home.
A leaking water heater can cause mold formation, mildew, and even rotting of walls, floors and sub-floors. Leaks in the water heater must be tended to immediately. Water leaks could be typically caused by one or more of the following reasons.
1) Faulty temperature and pressure valve
Place a container under the overflow pipe and open the temperature and pressure valve. Flush it to get rid of debris. If the valve still continues to leak, you need to replace it.
Do not try to stop the leak by capping off the valve as the valve releases excess pressure, which builds up inside the water heater due to overheating. Capping off the valve hinders its ability to release pressure and could lead to an explosion.
2) High pressure of the temperature and pressure valve
If your water heater is set to a high temperature, the temperature and pressure valve will remain open almost continuously to relieve the excess pressure, thus causing a leakage. This can easily be fixed by lowering the temperature of the thermostat. A lower temperature ensures that the valve does not remain open and the leakage will stop.
3) Leaking inlet and outlet pipes
Check the connections of the inlet and outlet water pipes to and from the water heater. If these are loose, it could be causing a leak. Tighten them as needed or replace in case of rusty pipes with holes in them.
4) Leaking water heater tank
Check the interior and exterior surfaces of the water tank carefully for any signs of rust or small holes. These could be caused due to corrosion and cannot be repaired. If you spot even a single hole, you need to replace your water tank. Consult any of your local water tank experts for the best replacement for your old water heater tank.
Rumbling noise coming from water heater
If your water heater makes a rumbling noise when turned on, it could be an indication of sediment build-up in the water tank. Flush the water tank to get rid of the sediment build-up. Repeat once in every three months to keep the build-up as low as possible.
No hot water
For gas water heaters
Check if the pilot light is on, if it is not, turn it on carefully or ask your gas company to relight the pilot light.
Ensure the gas controls are turned on, to the highest levels and check if the water heater is properly connected to the gas control unit.
Inspect the thermocouple. If it is defective, get it replaced immediately.
For electric water heaters
Check the fuse box/circuit breaker. If the water heater repeatedly blows fuses, contact a professional electrician.
Press the reset button to check the thermostat and heating element. If found defective, replace the thermostat and heating element. If the problem still persists, get in touch with a professional providing water heater repair services.
Insufficiently heated water
In the case of both gas and electric water heaters, turning up the thermostat and insulating the pipes connected to the water heater should fix this problem. If water is still not hot enough, consult professional water tank experts for your water heater repair needs.
These quick fixes can save your water heater from an early replacement and save you loads of money. Be sure to consult professionals if you are not skilled to undertake repairs on your own and avoid risking your personal safety.
Who doesn’t dread the thought of taking a cold shower on a chilly winter morning? To prevent waking up to a water heater failure, watch out for signs that could mean your water heater is failing.
Rumbling noise from the water tank
If your water heater makes a rumbling, gurgling noise when turned on, it could be a sign of sediment deposition in your water tank. This sediment buildup can shorten the lifespan of your water heater. It can lead to an early failure by corroding the internal parts of the heater. Flush your water heater once every three months to drain the sediment from the water heater tank and prevent water heater problems.
Insufficient hot water
If the water coming from your water heater is not getting heated enough, it could be an indication of water heater problems and should be looked into. Mineral deposits in your water tank could act as insulators and prevent the water from getting sufficiently heated. This could cause the water heater to consume more energy and over a period of time could lead to water heater failure. Ask your local plumber in Edmonton to inspect your water heater tank for mineral deposits and take necessary action.
Leaky water heater
Leaks in the water heater could point to underlying internal problems. Internal water heater problems should be checked out immediately and repaired at the earliest to avoid premature water heater failure. If water leaks from your water heater tank and pools on the ground, it is a major sign that your water heater is close to failing. It indicates that corrosion caused in the water heater has built up to the extent that it can penetrate the unit and cause a leak.
Metallic taste or smell
If the water coming from your water heater has a peculiar metallic taste or smell, it could be rusted on the inside and must not be ignored. Rusty, red or brown water could also indicate that your water heater has rusted. If not fixed immediately, the heater may begin to leak soon.
But if you have galvanized piping, the rust could be coming from your pipes. Get in touch with a plumber in Edmonton to ascertain the root of the rust and get it fixed.
Temperature and Pressure Valve
The safety relief valve inside your water heater helps release excess pressure in the water heater when the control fails and the tank overheats. If the valve is capped off to prevent it from leaking, it could cause a pressure build-up inside the water tank and even cause an explosion. This is a safety hazard and must be taken care of immediately. Replace leaking temperature and pressure valves instead of getting them capped. The temperature and safety valves must be examined by a plumber in Edmonton at least once a year to ensure they are functioning efficiently.
In addition to these signs of a water heater failure, ask a professional to conduct regular maintenance checks to make sure your water heater performs well for years to come. A professional can also guide you on which problems can be taken care of by conducting minor repairs and which ones require the water heater to be replaced.
Water heaters take up about 14-18% of your home energy consumption and you can easily reduce the money you spend on them. Your water heater can be made more energy efficient by trying these easy, cost effective tips handpicked by water tank experts. Read on to see how you can get the best use of your water heater at a much lower cost.
1) Purchasing a new water heater
For those of you who have water heaters older than 10 years, it might be worth considering an upgrade. Newer energy efficient water heaters are widely available and perform better than their older counterparts. Look for the energy star ratings or ask your local water tank experts for their opinion before zeroing in on a model. It might seem like an expensive option but it will save you big bucks in the future. Look for plumbers in Edmonton who provide installation, repair and maintenance services to help you select the right water heater.
2) Install low-flow faucets and showerheads.
Low-flow faucets and showerheads consume less water and have a higher water pressure. Installing them will reduce the amount of hot water that you use, which means less energy consumed by your water heater to heat water. Not only will these save your money on electricity, but will also save your water bill from skyrocketing.
3) Go tankless!
Water heaters with tanks store the hot water which eventually cools down and needs to be reheated, if not used up immediately. Gas-fired and tankless water heaters are the best examples of energy efficient water heaters available today. Tank-less water heaters do not store the heated water and instead heat water on demand, thereby using less energy.
4) Set the temperature to 120 degree Celsius
Setting your thermostat temperature to 120 degree Celsius limits the energy usage and saves you precious money on electricity. Bonus: it also prevents scalding!
5) Fix leaks
If your water heater is leaking, get it repaired as soon as possible. Leaky water heaters waste gallons of heated water per day. Get in touch with plumbers in Edmonton to repair all water heater leaks and save your money from going down the drain, literally.
6) Take showers, not baths
Your bathtub consumes a lot of hot water and stacks up your energy bill. Showers use less hot water than bathtubs and put less pressure on your water heater. Taking showers instead of baths in the tub will save you energy, water, and time!
7) Insulate, insulate, insulate!
Hot water tank experts recommend insulating the first 6ft of your pipes coming from the water heater. This prevents loss of heat and keeps your hot water, hot. Spend some money on insulation and make your water heater energy efficient.
Consider installing heat traps in your water tank as they can prevent the heat loss of stored hot water in the tank. Consult your local plumbers in Edmonton to find out more about heat traps.
8) Drain your water heater tank
Once in every three months, drain a quart of water from your water heater tank. This water, if not drained, causes sediment build-up that corrodes your water heater tank. A corroded water heater tank cannot perform to its optimum efficiency and requires more energy to heat water. Prevent corrosion due to sediment build-up and your heater will last a long time while consuming less energy.
Follow these tips to get the most out of your water heater and save loads of money on bills. Plumbers in Edmonton can help you with more tips to improve water heater efficiency.
Hot water heaters are a blessing on those freezing winter mornings. To keep them in excellent shape and avoid hot water heater problems, good water heater maintenance is a must. If not taken care of, these devices can be hazardous to you and your family. Protect yourself from unwanted accidents by following the water heater safety do’s and don’ts listed below.
Ensure your gas water heater is installed in an area with adequate ventilation. Gas water heaters can leak carbon monoxide, which is odorless but can be toxic if inhaled. Get a professional to check your ventilation and for water heater maintenance to avoid leaks in future.
Set your water heater thermostat temperature to 120 degrees Celsius. Temperatures higher than 120 degrees Celsius can cause scalding, especially for young children.
Prevent the possibility of fire by storing flammable liquids such as paint cans, cleaning fluids, gas cans away from your gas hot water heater.
Sediment buildup in the hot water tank can cause corrosion and other water heater problems. Flush it once every three months to get rid of build up residue and prevent the need for hot water tank repair.
Get it serviced by a professional as regular water heater maintenance is essential for its smooth functioning and long life.
When going away for many days, set the water heater temperature to its lowest setting. This will save energy and avoid the risk of any hot water heater problems from occurring while you are away.
Check the safety valve at least once a year. If you don’t know how to, contact a water heater professional to detect early signs of hot water heater problems.
Don’t leave children unattended near a water heater
Don’t try to undertake hot water tank repair by yourself if you don’t know what you are doing. Always consult a professional.
Don’t ignore the signs that water heater maintenance is due. A minor problem today could cause a huge disaster tomorrow.
Don’t wait too long to call for hot water tank repairs, especially if you notice a leak.
Follow these tips for safe and efficient use of the water heater and to ensure it lasts for a long time before it is time to replace it.
Thanks to the latest innovations, you have lot many water heater choices in the market to choose from, that are both energy efficient and long lasting. Tankless hot water Edmonton has always been the first choice for many home owners thanks to their ease of maintenance and use. In this article, we are going to discuss some of the latest water heaters and how they help you save the money in the longer run.
If you are going to invest in a good quality water heater then you could look forward to years of trouble free life. New age water heaters come with long warranties and even if something goes wrong with them, you can get them repaired free of cost. Hot water tanks Edmonton prices have shot up in the recent times and if you have more than one water heater at home, then you might be interested in taking good care of it as replacing them can be an expensive affair. Here are the 5 signs indicating that your water heater is in need of repairs.
Water heater maintenance must be done on regular basis to keep the water heater in best of condition. This means that you could expect more life from the heater and it will also help you save a lot on the energy bills. So what are the pints that must be kept in mind before you plan maintenance for the water heater? To start with, you need to ensure that you are getting it done by a professional tankless hot water Edmonton company. The storage tank water heater and the electric hot water heaters Edmonton both needs some or the other type of maintenance check from time to time. As you must have noticed, the water heaters are one of the most used equipments of the house and this is why they usually are the first plumbing appliance to break down, but when you can spot some signs of trouble you can help extend that life a while longer.
If you are going to compare the efficiency of a storage tank water heater with tankless hot water Edmonton, then they are less efficient and are prone to more break-ups. That is why it is highly recommended that you must go for a new model if you have a heater that is more than 10-12 years old. New age water heater also comes with longer warranties and most of the parts are covered under it. The areas that you need to check are rust at the tank, loud banging noises when the heater is operational and rust particles in the water. If you see the particles of rust, then it is highly recommend that you must get the tank cleaned on immediate basis. From time to time, you need to get the tank flushed properly to get rid of all the sediment and rust deposits. Never try to flush the tank by yourself and always call tankless hot water Edmonton for the job.
Hot water heater can give you long life if you are going to maintain them on proper basis. Storage tank water heaters are not popular now and the best choice to go for are the tankless water heaters. These water heaters require lot less maintenance and you also don’t have to worry about the tank getting rusted, or too much of sediment deposit. As they don’t have to heat up the stored water, they also consume lot less energy. Many new age electric hot water heaters come with 10-15 years of warranty, so if something goes wrong with the heating element or the body, all you have to do, is to call in the technician, and the problem will be taken care of for free.
The easiest way to detect the problems of your water heater is to get it checked on regular basis. This ensures that your water heater is running fine all the time and if there is any issue regarding the heating for the water or the operation of the components, you will be getting to know about them before they take a major and expensive turn. Many hot water heater repair companies suggest you to take maintenance packages for water heaters that lets you get them checked once in every 6 months to make sure they are working at top of their efficiency.