Hot water is a home necessity for daily comfort and convenience. You rely on your water heater for activities such as cooking, cleaning, and bathing. When your water heater is inefficient or inconsistent, it can cause difficulty completing these tasks and affect your daily schedule, as well as raise your monthly utility costs.
Let’s take a look at a few advantages of a professional water heater installation.
Whether you have a water heater that’s a jerk or you have a faulty water heater, Hot Water Tank Edmonton, is the right place when it comes to picking up the right water tank heater.
All appliances have a certain life time period. Your water heater is also going to break down over time. You wouldn’t like to have a cold shower suddenly one fine day, right? It will be better if you are able to replace water heater before it dies. For that, you need to identify when you water heater is dying and know when you need a hot water tank installation.
Age of the Heater
Age is an important point when to replace water heater. The older the water heater, the higher the chance it will break down. On an average, the lifespan of electric water heaters is about 8-10 years, while the gas water heaters last for a good 6-8 years. So, do a check on how old is your water heater. If your investigation reveals that it is any older than the one mentioned above, you should better think of replacing the heater.
Rusting and Corrosion
If you find that the tank is rusting or has corrosion, then it is highly recommended that you should replace water heater. You might notice that there is rust in your water that runs from the tap. However, there is no other way to deal with such problems. The initial rusting and corrosion will only lead to leakages in the heater.
Unable to Drain
There are sediments that built and settle inside the bottom of the tank. The routine disposition of the sediments is going to ruin the interiors of the tank. Furthermore, it will clog the drain valve. If you flush the water once or twice a year, it will prevent the damage. This will also extend the life of your water heater. But if the problem continues, then you need a new hot water tank installation and that should be done urgently.
Leakage in the Tank
The reason why your tank might leak is because of some internal issue. If you have any internal issue, then it is almost impossible to repair. Also if the leak is in the tank, then you have to go for a professional heater installation. Other than that, there is not much you can do in order to save your water heater.
You get Luke Warm Water
Imagine that you are wanting to have a hot water bath, but all you get is lukewarm water. The heating element within the tank has grown old. There also might be a chance that the amount of hot water required by your house has increased and the current hot water heater is not matching to your needs. Now that is when you must go for a new hot water tank installation.
Now that you know what all you need to look for when you are thinking to buy a new water heater, what you should do is that you should prefer to have a professional heater installation rather than doing it yourself. Hot Water Tank Edmonton is the right place when it comes to dealing with hot water tank installation.
Without a water heater, you aren’t going to have an enjoyable bath. So, what if you water heater was giving your problems? In this tutorial, we will walk through some of the most common ways to troubleshoot and repair electrical water heater problems.
Reset Circuit Breaker
If you don’t have hot water, reset the tripped reset circuit breaker or check if you have a blown switch. You should also confirm that the power is being provided to the electric water heating element thermostat.
Check The Water Capacity
Control Water Leaks
Install Low Watt Density Elements
Whether you are looking to troubleshoot your electric water heater, Hot Water Tank Edmonton , has the best remedies when it comes to solving electrical water heater problems .
Imaging you’re having a nice, warm shower when suddenly ice cold water splashes onto you. You have water heater problems. Your water heater is acting like a jerk and not allowing you to have a nice, warm shower. Like any other appliance, problems can come up. Here are a few very common water heater problems which can popup any given day.
Water Leaking From The Top
If you believe you have a leak near the top of your electric water heater, it could be one of a few things. The cold inlet or hot outlet pipes may be loose, the T&P valve may have failed, or the inlet valve may be leaking.
Not Enough Hot Water
Water in an electric water heater is heated by two heating elements (in most cases). The most common reason for absolutely no hot water is that the circuit breaker has tripped. It may be an issue with the switch on the thermostat. Not enough water or no hot water is another reason your water heater might be acting like a jerk.
Water Is Too Hot
This is similar to the earlier reason. It is likely related to the thermostat in the heater. If you cannot lower the water temperature low enough, you may need to replace your thermostat or there may be some type of wiring issue. The excessive water temperature is also one of the hot water issues.
Low Water Pressure
Having low pressure can also result in hot water issues. Those reporting low hot water pressure have an older home with 1/2-inch diameter galvanized piping that enters and leaves the water heater. Sediment, calcium-deposits, and rust inside your plumbing or sink aerators may also contribute to low hot water pressure.
Smelly Hot Water
Water with a stinking smell is one of the common water heater problems. Most likely, the smelly or stinky hot water is due to bacteria in the tank. Homes which use well water as their water source are more susceptible to their water giving off a foul odor.
An unwanted noise coming from inside the tank could be a major water heater problems. It can be the sound of sediment being burned by the heating element, or the heating element itself could be slowly burning out and becoming noisy in its deterioration.
Water Takes Time To Reheat
This is one of the downsides with electric water heaters. On average, recovery time (time it takes to reheat entire supply of water) on an electric model is double that of a comparable gas model. That said, if it’s taking longer than usual for the hot water to recover, there may be an issue with the heating elements. If it takes longer than regular to reheat, then it is a prominent problem among the water heater problems.
Whether you have a water heater that’s a jerk or you have a faulty water heater, Hot Water Tank Edmonton, has the best remedies when it comes to solving hot water issues.
No one wants a high hot water bill. The good news is that there are multiple ways for you to reduce your hot water heater bill. This write up will help you with a few tips that can reduce your power bill.
Whether you're looking for no-cost habit changes, low-cost purchases or improvements, or large investments like new water heaters or appliances Edmonton Hot Water Tanks , has the best remedies when it comes to reducing the hot water heater bill.
The hot water tank is probably the most expensive component of your company’s plumbing system. And the hot tank repair is also very costly. Most of the problems related to the hot water tank can be figured out easily and fixed without the help of an expert plumber. Thus, you can save some money on the expenses to be made on repairs. But, some problems have to undergo the hot tank repair. Here are some indications that will tell you that your water heater is failing.
No Hot Water
Hot water runs out very quickly? Your thermostat might be set too low or you might need to replace the thermostat. If everything is fine with the thermostat, there might be a mineral build-up in the tank. This mineral build-up eats up a lot of space and destroys the component used for heating, and hampers the water heater’s capacity to heat water. It can also make the hot water tank less efficient and shorten its lifespan.
It is very important to know the age of your water heater. You can find out the age of the water heater by checking the serial number on the manufacturer’s sticker that is on the top of the water heater. The hot water tanks that are older than 10 years should be considered for replacement or you might find out that the water heater is failing.
The most common indication to find out if your hot water tank needs to be replaced is when there is leakage. When your tank gets old, it starts to leak from places you cannot see that is leaking through a welded joint or a side wall seam. In such cases, you cannot get a hot tank repair done and so you would need to replace it. You have to fix the problem of leaking as soon as possible to prevent flooding and other damages.
A hot water tank that makes weird noises of banging, creaking, knocking or whining is the worst. It does not let you live in peace. Most of the noise issues occur because of the mineral build-up inside the tank. The debris come in contact with the heating element and gives out a lot of noise. Sometimes, flushing the tank can solve this problem. If you have flushed out the tank but still the noises continue to persist, you should understand that the water heater is failing and it is time for it to be replaced.
If you find out any of the above indications in your hot water tank, you must consider that your water heater is failing and must look out for a professional plumber to get the hot tank repair done.
Water heaters are the type of gadgets that add comfort to our lives. While they are working properly, we don’t pay much attention to them. But, when they stop working we definitely have a bad time without hot water and start looking for water tank repairs. One of the major problems that occur to the water tank is leakage. The problem of leakage in the water tank might be the cause of many things. Some of the things that lead to water tank leaks are listed below.
A loose drain valve is one of the most common reasons for water tank leaks. You can easily tighten the drain valve by using a wrench. The only thing to be careful about while tightening the drain valve is that it should not be over-tight. Tighten it until it is closed, but do not force it too hard or it might break.
All things come with an expiry date, so do the water tanks. Normally, water tanks are designed to last for many years. As they come closer to the end of their expiry date, the water tanks start to rust and corrosion takes place. When the corrosion gets bad, it leads to water tank leaks. When this happens, one must understand that the water tank is up for replacement and no amount of water tank repairs will help. If you do not replace the tank immediately, it might lead to a major breakdown of the water tank and could lead to water flooding in the house.
When the tank builds up a lot of pressure inside, the water tank might start to leak out water. When too much pressure builds up, the excess pressure forces the water to leak out of the tank to reduce the pressure inside. The pressure often rises when the hot water heating level is set too high. It can also happen if the exterior water supply of the house comes in with excess force. One will have to find a plumbing expert to fix this problem and prevent water tank leaks.
Sometimes we might think that there are water tank leaks when actually there is nothing. Condensation takes place on hot water heaters, which is normal. When cold water starts entering the tank, it leads to condensation as the air is hot. This is not a great problem. One can just wipe down the water on the exterior body of the water tank without worrying about major issues. And this does not require any water tank repairs.
These are few problems that cause water tank leaks which one will be able to find out at home but might not be able to solve them at home always. One needs to contact a plumbing expert who will fix the leaks and let the water tank continue to be a bliss to your family.
It is always better to carry out regular water heater maintenance. Instead of carrying out water tank repairs, if you regularly maintain the water heater you can increase its life.
Water tank repair is only necessary when there is a major fault in the system. You can regularly carry out water heater maintenance using the following important tips.
Watch For Problems
Repair the problems which are visible to the naked eye. Do not procrastinate and delay as they may culminate into bigger problems. Nip them in the bud. A small leak? Get it fixed. Water tank isn’t heating water properly? Call a hot water heater technician today to get that tank repaired. The longer you delay problems related to plumbing or heater maintenance, the more it’s going to cost you in the long run.
Clean The Area Around The Water Heater
There are several reasons why it's a good idea to give your water heater some space. A gas-fired unit needs a good supply of oxygen to burn the gas. If a water heater is smothered and can’t get enough oxygen, it can affect the efficiency of the unit as well as cause damage to the burner chamber and other water heater parts. It can also cause carbon monoxide leaks. If the unit starts to leak, you may not be able to detect it soon if the area is hidden from view. This has the potential to cause severe water damage and even waste energy as the water heater has to reheat the water more often. Storing items too close to the water heater can be a fire hazard.
Drain Your Water Heater
At least once a year, drain a few gallons out of your water heater using the drain valve. Use either a 5-gallon bucket or a garden hose and run it to a place where the hot water will not cause damage. (Do not drain it to your landscaping or lawn, as hot water may kill the grass.) If you notice a lot of sediment or debris, then a full flush is recommended. This is where you turn the temperature down and then completely drain the tank. You then turn the water back on while the drain is open and let the water flow for a minute or so to help remove any lingering sediment or debris. Once that is done and the tank has been refilled, turn the thermostat back to the desired setting
Annual Water Heater Inspection
Start with the top of your water heater and check for any corrosion on the pipes and valves. For gas water heaters, check the draft hood and make sure it is placed properly, with a few inches of air space between the tank and where it connects to the vent. Look for any corrosion or wear on the gas line and on the piping. Check the thermostat and the area below the thermostat, where the gas chamber is located.
With a few tools of your own and some basic knowledge, you can always maintain your water heater. Increase your knowledge related to water tank repair, with relation to plumbing. This will help you avoid things that cause damage and will help you lengthen the life of the water heater.