Water heaters are the type of gadgets that add comfort to our lives. While they are working properly, we don’t pay much attention to them. But, when they stop working we definitely have a bad time without hot water and start looking for water tank repairs. One of the major problems that occur to the water tank is leakage. The problem of leakage in the water tank might be the cause of many things. Some of the things that lead to water tank leaks are listed below.
Drain Valve A loose drain valve is one of the most common reasons for water tank leaks. You can easily tighten the drain valve by using a wrench. The only thing to be careful about while tightening the drain valve is that it should not be over-tight. Tighten it until it is closed, but do not force it too hard or it might break. Old Tank All things come with an expiry date, so do the water tanks. Normally, water tanks are designed to last for many years. As they come closer to the end of their expiry date, the water tanks start to rust and corrosion takes place. When the corrosion gets bad, it leads to water tank leaks. When this happens, one must understand that the water tank is up for replacement and no amount of water tank repairs will help. If you do not replace the tank immediately, it might lead to a major breakdown of the water tank and could lead to water flooding in the house. Excess Pressure When the tank builds up a lot of pressure inside, the water tank might start to leak out water. When too much pressure builds up, the excess pressure forces the water to leak out of the tank to reduce the pressure inside. The pressure often rises when the hot water heating level is set too high. It can also happen if the exterior water supply of the house comes in with excess force. One will have to find a plumbing expert to fix this problem and prevent water tank leaks. Condensation Sometimes we might think that there are water tank leaks when actually there is nothing. Condensation takes place on hot water heaters, which is normal. When cold water starts entering the tank, it leads to condensation as the air is hot. This is not a great problem. One can just wipe down the water on the exterior body of the water tank without worrying about major issues. And this does not require any water tank repairs. These are few problems that cause water tank leaks which one will be able to find out at home but might not be able to solve them at home always. One needs to contact a plumbing expert who will fix the leaks and let the water tank continue to be a bliss to your family.
0 Comments
You turn the handle for hot water in the shower and all you get is cold water. What’s up with that? You can’t figure out but you assume that it has something to do with your hot water tank kept in the basement. You take a look at the hot water tank and you can’t make out what’s wrong.
It is literally not possible to know each and everything to household chores. That’s why we are here to help you out. When it’s time to replace the water heater, don’t try to do it on your own unless you are an expert at recognizing plumbing issues. Water heater replacement requires the knowledge of a few things that only a professional will be able to help you out with. Heat it while you fit it Soldering connections of pipes during heater replacement too close to the hot water tank is a common mistake committed. The heat it takes to melt solder can also melt plastic fittings inside the tank. A better way to make the connections is to unscrew the nipples from the top of the tank and take them to a work bench to solder on the needed pipe and fittings. Leave only one connection to solder after you replace the nipples, and make it as far from the tank as possible. Not being able to connect the temperature and pressure relief valve correctly Temperature and pressure relief valves on the water heater, open once the temperature or even the pressure in the tank has exceeded their corresponding threshold values. When these valves have been connected wrongly, there is that chance that you might be sprayed with scalding water. This mistake can eventually lead to an injury. It is very much important to connect these valves then to a watertight pipe whose length reaches and extends to half feet of the floor. In case the valves are to be connected on top of the tank, you should always have the overflow tube extending from the top going down to the tank’s side then extending to the floor. Install things carefully. Pay special attention It is very important to understand the type of material that has been used in the making of your water tank. Using identical or material that doesn’t corrode on coming in contact with water and the other material (physics 101: A metal with a higher electrical potential will corrode the metal with a lower electric potential when they come in contact with an electrolyte). Fresh potable water is a weak electrolyte. Salt water or acid solutions are good electrolytes, hence the use of an acid solution in an automotive battery . These are a few of the many things you need to keep in mind when you’re installing a hot water tank or you’re changing the heater. When you don’t know what all things that need to be considered, heater replacement is best left to the professionals like Edmonton Plumbers, who will get the job done without any mistakes. ![]() The life of your water heater depends upon lot of factors and if you are looking forward to get a good life from your heater, you need to ensure that you are getting it maintained on regular basis. Edmonton hot water heater repair experts recommended that you must get the water heater checked once in every six months so that if any problem is there in the heating unit, you will get to know about it on early basis and this will also save you a lot on the expensive repairs. Most of the home owners don’t have any idea when it comes to the right repair and maintenance of the unit and most of them don’t even look at their water heater. It is very much important for you to keep the number of an Edmonton hot water heater repair expert handy, so that if you face any emergency, you might be able to get the right help at the right time. The first and the basic sign of water heater maintenance are not getting the right temperature of water even after setting up the thermostat at the desired setting. One of the two reasons might be the culprit behind it; scaling inside the tank or a worn out heating element. If the water heater is making loud noises while heating up the water, then it might be the right time to call in the water heater expert and get the tank cleaned. Another cause could be that the thermostat on the water heater is broken and as it is not too expensive to get replaced, it will be a good idea to get the unit replaced than to get it repaired. Water heaters also tend to develop leaks over the period of time and if your water heater is more than 5-7 years old, then you must check the water heater from time to time. The leaks might be due to the faulty gaskets, worn out valves or from too much pressure building up inside of the tank. If you see water droplets at the bottom of the tank, then you must call the Edmonton hot water heater repair professional. Most of the home owners also complain about lot of noise while the heater is operational and the reason behind it is the sediment deposit inside the tank. To get rid of the problem, you need to get the tanks flushed so that all the minerals that have accumulated at the bottom of the tank get cleaned. Always keep a vigilant eye at these signs and if your water heater hasn’t been serviced from a long time, get it done on immediate basis. |
Archives
November 2017
Categories
All
|