Hot water is a home necessity for daily comfort and convenience. You rely on your water heater for activities such as cooking, cleaning, and bathing. When your water heater is inefficient or inconsistent, it can cause difficulty completing these tasks and affect your daily schedule, as well as raise your monthly utility costs.
Let’s take a look at a few advantages of a professional water heater installation.
Whether you have a water heater that’s a jerk or you have a faulty water heater, Hot Water Tank Edmonton, is the right place when it comes to picking up the right water tank heater.
13 Comments
All appliances have a certain life time period. Your water heater is also going to break down over time. You wouldn’t like to have a cold shower suddenly one fine day, right? It will be better if you are able to replace water heater before it dies. For that, you need to identify when you water heater is dying and know when you need a hot water tank installation.
Age of the Heater Age is an important point when to replace water heater. The older the water heater, the higher the chance it will break down. On an average, the lifespan of electric water heaters is about 8-10 years, while the gas water heaters last for a good 6-8 years. So, do a check on how old is your water heater. If your investigation reveals that it is any older than the one mentioned above, you should better think of replacing the heater. Rusting and Corrosion If you find that the tank is rusting or has corrosion, then it is highly recommended that you should replace water heater. You might notice that there is rust in your water that runs from the tap. However, there is no other way to deal with such problems. The initial rusting and corrosion will only lead to leakages in the heater. Unable to Drain There are sediments that built and settle inside the bottom of the tank. The routine disposition of the sediments is going to ruin the interiors of the tank. Furthermore, it will clog the drain valve. If you flush the water once or twice a year, it will prevent the damage. This will also extend the life of your water heater. But if the problem continues, then you need a new hot water tank installation and that should be done urgently. Leakage in the Tank The reason why your tank might leak is because of some internal issue. If you have any internal issue, then it is almost impossible to repair. Also if the leak is in the tank, then you have to go for a professional heater installation. Other than that, there is not much you can do in order to save your water heater. You get Luke Warm Water Imagine that you are wanting to have a hot water bath, but all you get is lukewarm water. The heating element within the tank has grown old. There also might be a chance that the amount of hot water required by your house has increased and the current hot water heater is not matching to your needs. Now that is when you must go for a new hot water tank installation. Now that you know what all you need to look for when you are thinking to buy a new water heater, what you should do is that you should prefer to have a professional heater installation rather than doing it yourself. Hot Water Tank Edmonton is the right place when it comes to dealing with hot water tank installation. Imaging you’re having a nice, warm shower when suddenly ice cold water splashes onto you. You have water heater problems. Your water heater is acting like a jerk and not allowing you to have a nice, warm shower. Like any other appliance, problems can come up. Here are a few very common water heater problems which can popup any given day.
Water Leaking From The Top If you believe you have a leak near the top of your electric water heater, it could be one of a few things. The cold inlet or hot outlet pipes may be loose, the T&P valve may have failed, or the inlet valve may be leaking. Not Enough Hot Water Water in an electric water heater is heated by two heating elements (in most cases). The most common reason for absolutely no hot water is that the circuit breaker has tripped. It may be an issue with the switch on the thermostat. Not enough water or no hot water is another reason your water heater might be acting like a jerk. Water Is Too Hot This is similar to the earlier reason. It is likely related to the thermostat in the heater. If you cannot lower the water temperature low enough, you may need to replace your thermostat or there may be some type of wiring issue. The excessive water temperature is also one of the hot water issues. Low Water Pressure Having low pressure can also result in hot water issues. Those reporting low hot water pressure have an older home with 1/2-inch diameter galvanized piping that enters and leaves the water heater. Sediment, calcium-deposits, and rust inside your plumbing or sink aerators may also contribute to low hot water pressure. Smelly Hot Water Water with a stinking smell is one of the common water heater problems. Most likely, the smelly or stinky hot water is due to bacteria in the tank. Homes which use well water as their water source are more susceptible to their water giving off a foul odor. Unwanted Noise An unwanted noise coming from inside the tank could be a major water heater problems. It can be the sound of sediment being burned by the heating element, or the heating element itself could be slowly burning out and becoming noisy in its deterioration. Water Takes Time To Reheat This is one of the downsides with electric water heaters. On average, recovery time (time it takes to reheat entire supply of water) on an electric model is double that of a comparable gas model. That said, if it’s taking longer than usual for the hot water to recover, there may be an issue with the heating elements. If it takes longer than regular to reheat, then it is a prominent problem among the water heater problems. Whether you have a water heater that’s a jerk or you have a faulty water heater, Hot Water Tank Edmonton, has the best remedies when it comes to solving hot water issues. ![]() Who doesn’t dread the thought of taking a cold shower on a chilly winter morning? To prevent waking up to a water heater failure, watch out for signs that could mean your water heater is failing. Rumbling noise from the water tank If your water heater makes a rumbling, gurgling noise when turned on, it could be a sign of sediment deposition in your water tank. This sediment buildup can shorten the lifespan of your water heater. It can lead to an early failure by corroding the internal parts of the heater. Flush your water heater once every three months to drain the sediment from the water heater tank and prevent water heater problems. Insufficient hot water If the water coming from your water heater is not getting heated enough, it could be an indication of water heater problems and should be looked into. Mineral deposits in your water tank could act as insulators and prevent the water from getting sufficiently heated. This could cause the water heater to consume more energy and over a period of time could lead to water heater failure. Ask your local plumber in Edmonton to inspect your water heater tank for mineral deposits and take necessary action. Leaky water heater Leaks in the water heater could point to underlying internal problems. Internal water heater problems should be checked out immediately and repaired at the earliest to avoid premature water heater failure. If water leaks from your water heater tank and pools on the ground, it is a major sign that your water heater is close to failing. It indicates that corrosion caused in the water heater has built up to the extent that it can penetrate the unit and cause a leak. Metallic taste or smell If the water coming from your water heater has a peculiar metallic taste or smell, it could be rusted on the inside and must not be ignored. Rusty, red or brown water could also indicate that your water heater has rusted. If not fixed immediately, the heater may begin to leak soon. But if you have galvanized piping, the rust could be coming from your pipes. Get in touch with a plumber in Edmonton to ascertain the root of the rust and get it fixed. Temperature and Pressure Valve The safety relief valve inside your water heater helps release excess pressure in the water heater when the control fails and the tank overheats. If the valve is capped off to prevent it from leaking, it could cause a pressure build-up inside the water tank and even cause an explosion. This is a safety hazard and must be taken care of immediately. Replace leaking temperature and pressure valves instead of getting them capped. The temperature and safety valves must be examined by a plumber in Edmonton at least once a year to ensure they are functioning efficiently. In addition to these signs of a water heater failure, ask a professional to conduct regular maintenance checks to make sure your water heater performs well for years to come. A professional can also guide you on which problems can be taken care of by conducting minor repairs and which ones require the water heater to be replaced. |
Archives
November 2017
Categories
All
|